Theft Deterrent / Keyless Entry

Precautions

~2min read

PRECAUTION

PRECAUTIONS FOR ELECTRICAL DEVICE INTERFERENCE

CAUTION:

  • People with an implanted cardiac pacemaker, a cardiac resynchronization therapy pacemaker or an implantable cardioverter defibrillator must keep a reasonable distance from the smart key system antennas. Radio waves may affect the proper operation of these devices. If necessary, the entry function can be deactivated. Ask your dealer for information, in particular about the radio wave frequency and the radio wave emission duration. Then consult your doctor to find out whether you need to deactivate the entry function.

    Click here

  • Users of electrical medical equipment other than an implanted cardiac pacemaker, CRT-D or ICD must consult the equipment manufacturer for information on its operation under the influence of radio waves. Radio waves may have unexpected effects on the operation of such equipment.
  • Ask the dealer for information on deactivating the entry function.

PRECAUTIONS FOR USING THE TECHSTREAM

(a) When using the Techstream with the engine switch in the OFF position, connect the Techstream to the DLC3 and turn a room light switch ON and OFF at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle starts. Then select the vehicle type manually and enter the following menus: Body Electrical / Smart Key. When using the Techstream, periodically switch a room light switch between ON and OFF at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.

REGISTRATION PRECAUTIONS

(a) When replacing any of the following parts, refer to the registration procedures.

(1) Certification ECU (smart key ECU assembly)

(2) Steering lock ECU (steering lock actuator or upper support assembly)

(3) ECM

(4) Electronic Key Transmitter Sub-assembly

(5) ID code box (immobiliser code ECU)

(6) Main body ECU (multiplex network body ECU)

(b) When the certification ECU (smart key ECU assembly) is replaced, the registered steering lock position will no longer match that of the steering lock ECU (steering lock actuator or upper bracket assembly), and it may be impossible to start the engine. Therefore, after replacement, perform the following procedure.

(1) Place the shift lever in the P position.

(2) With the engine switch in the OFF position, open and close a door, then start the engine.