Brake Switch "B" Circuit High (P0724)
DESCRIPTIONThe purpose of this circuit is to prevent the engine from stalling while driving in the lock-up condition when the brakes are suddenly applied. When the brake pedal is depressed, this switch sends a signal to the ECM. Then the ECM cancels the operation of the lock-up clutch while braking is in progress.
MONITOR DESCRIPTIONThis DTC indicates that the stop light switch remains ON. When the stop light switch remains ON during GO and STOP driving, the ECM interprets this as a fault in the stop light switch. Then the MIL illuminates and the ECM stores the DTC. The vehicle must GO (30 km/h or more) and STOP (less than 3 km/h) 5 times for 2 driving cycles in order for the DTC to be output. MONITOR STRATEGY
TYPICAL ENABLING CONDITIONS
TYPICAL MALFUNCTION THRESHOLDS
CONFIRMATION DRIVING PATTERN
WIRING DIAGRAMRefer to DTC P0504 (See page HINT: Using the Techstream to read the Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time. NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
PROCEDURE
(a) Remove the stop light switch. (b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
(b) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
