BMW 1 Quiz
Body

Removal and Installation of Front Bumper Dampers

In this manual: Body
Introduction — 10Owner's Manual — 29Routine Care and Maintenance — 30Engine — 18Cooling and Heating Systems — 13Fuel and Exhaust Systems — 29Engine Electrical Equipment — 20Manual Transmission — 4Automatic Transmission — 4Clutch and Drive Shafts — 12Brake System — 19Suspension and Steering — 22Body — 36Body Electrical Equipment — 34Electrical Circuit Diagrams — 30On-board diagnostic system — 5
~1min read
0204060801005037N·mlb·ft
Tightening torque found on this page

PROCEDURE

1. Remove the front bumper.
2. Remove the three mounting bolts (2/3) and remove the damper (1). Disconnect the cable holder (4).

УСТАНОВКА

INSTALLATION

1. Install the damper and tighten it to torque 50 N·m and 10 N·m.
2. Secure the air guide, if it was removed.
3. Secure the cable harness and fix the cable.
4. Install the front bumper.

Test yourself

A quick BMW 1 quiz: every answer comes with an explanation and a link to the manual page.