BMW 1 Quiz
Body

Removal and Installation of Rear Bumper Damper

In this manual: Body
Introduction — 10Owner's Manual — 29Routine Care and Maintenance — 30Engine — 18Cooling and Heating Systems — 13Fuel and Exhaust Systems — 29Engine Electrical Equipment — 20Manual Transmission — 4Automatic Transmission — 4Clutch and Drive Shafts — 12Brake System — 19Suspension and Steering — 22Body — 36Body Electrical Equipment — 34Electrical Circuit Diagrams — 30On-board diagnostic system — 5
~1min read
0204060801004533N·mlb·ft
Tightening torque found on this page

REMOVAL

1. Remove the rear bumper.
2. Remove the mounting bolts (1) and remove the damper.

УСТАНОВКА

INSTALLATION

1. Install the damper so that the center pin (2) points upward. Screw in the bolts without tightening them.
2. Disconnect the frame protection plate.
3. Install the rear bumper.
4. Tighten the mounting bolt (1) to torque 45 N·m.

5. Закрепите защитную планку рамы.

5. Secure the frame protection plate.

Test yourself

A quick BMW 1 quiz: every answer comes with an explanation and a link to the manual page.