BMW 1 Quiz
Body

Rear Seat Removal and Installation

In this manual: Body
Introduction — 10Owner's Manual — 29Routine Care and Maintenance — 30Engine — 18Cooling and Heating Systems — 13Fuel and Exhaust Systems — 29Engine Electrical Equipment — 20Manual Transmission — 4Automatic Transmission — 4Clutch and Drive Shafts — 12Brake System — 19Suspension and Steering — 22Body — 36Body Electrical Equipment — 34Electrical Circuit Diagrams — 30On-board diagnostic system — 5
~1min read

REMOVAL

1. Pull the seat firmly upward on both front sides to release it from the clips.
2. Pull the seat slightly forward from under the seatback. Allow the seat belt to retract and remove the seat from the vehicle.
3. Remove the seatback mounting bolts on the left and right sides.

4. Поднимите средний подголовник до упора вверх и затем с силой вытяните его.

4. Raise the center head restraint fully upward, then pull it out with force.
5. Remove the seatback.

INSTALLATION

1. Insert the seatback into the belt, move it downward and secure it. If necessary, bend the seat belt pretensioner outward.

2. Закрепите спинку по бокам болтами.

2. Secure the seatback on both sides with bolts.
3. Insert the center head restraint and lower it.
4. Insert the seat belt buckles through the openings of the rear seats.
5. Insert the rear seat back under the seatback so that the front brackets are under the tabs in the vehicle floor. In this position, press the seat firmly downward and secure it.

Test yourself

A quick BMW 1 quiz: every answer comes with an explanation and a link to the manual page.