BMW 1 Quiz
Body

Rear Window Shade Removal and Installation

In this manual: Body
Introduction — 10Owner's Manual — 29Routine Care and Maintenance — 30Engine — 18Cooling and Heating Systems — 13Fuel and Exhaust Systems — 29Engine Electrical Equipment — 20Manual Transmission — 4Automatic Transmission — 4Clutch and Drive Shafts — 12Brake System — 19Suspension and Steering — 22Body — 36Body Electrical Equipment — 34Electrical Circuit Diagrams — 30On-board diagnostic system — 5
~1min read
0102030405032N·mlb·ft
Tightening torque found on this page

REMOVAL

1. Remove the hat rack.
2. Release the electrical wires (1). Refer to the supporting illustration.
3. Unscrew the nuts (2).
4. Disconnect the clips (3).

5. Снимите козырьки слева и справа. Для этого снимите зубчатые шайбы.

5. Remove the visors on the left and right. To do this, remove the toothed washers.
6. Remove the shade from the hat rack.

INSTALLATION

1. Install and secure the shade (3 N·m).
2. Install the clips and visors.
3. Route the electrical wires into the guides.
4. Install the hat rack.

Test yourself

A quick BMW 1 quiz: every answer comes with an explanation and a link to the manual page.