On-Board Computer

The following information is displayed on the trip computer display:

Instant fuel consumption

Kilometer display

: Fuel consumption is indicated in L/100 km.

Mile display

: Fuel consumption is indicated in miles per gallon.

Vehicles with diesel engine

If the diesel particulate filter has recently been regenerated, the displayed instant fuel consumption value may be higher than the actual value. For more information, refer to page 577.

Driving range on fuel

: Estimated distance your vehicle can travel on the fuel remaining in the tank.

This distance is calculated based on fuel consumption over the last few kilometers (miles) driven and may change depending on changes in driving speed, road conditions, etc.

Travel time

: Time elapsed since the ignition switch was turned to the ON (II) position.

Average Speed

: Average driving speed is displayed in km/h (or mph) depending on the vehicle version.

Average Fuel Consumption

: Average fuel consumption for the period since the trip A odometer was last reset.

: Average fuel consumption for the period since the trip B odometer was last reset.

The average fuel consumption is updated on the display every 10 seconds. When the trip odometer is reset, the average fuel consumption value for that trip is also reset to zero. To reset the trip meters, press and hold the SEL/RESET button until “0.0” appears on the display.

In the custom settings mode, you can enable the function that resets the trip A odometer and the trip A average fuel consumption when refueling the fuel tank.

In normal mode, the lower part of the display always shows the odometer, trip odometer, and outside air temperature indicator.

Odometer

The odometer shows the total distance the vehicle has traveled over its entire service life, in kilometers or miles.

Trip odometer

The trip odometer shows the distance the vehicle has traveled, in kilometers or miles, since it was last reset.

The vehicle is equipped with two trip odometers: trip A and trip B. To switch between the trip A and trip B displays, press the SEL/RESET button repeatedly. When the ignition switch is turned to the ON (II) position, the last selected parameter is displayed.

The trip odometers operate independently of each other, which makes it possible to measure distances traveled on different routes.

To reset the trip odometer, display its reading, then press and hold the SEL/RESET button until “0.0” appears on the display.

Symbolorappears in the upper part of the display depending on which trip (A or B) is selected in the lower part of the display.

Outside Air Temperature Indicator

This indicator shows the outside air temperature in degrees Celsius.

The temperature sensor is built into the front bumper. Therefore, the measured temperature value may be affected by heat radiation from the road surface, heat emitted by the engine, and exhaust heat from vehicles in traffic. When driving at speeds below 30 km/h, measurement errors may be significant.

Temperature values are updated on the display with a delay required for the sensor to heat up or cool down to the outside air temperature. This delay may last several minutes.

If the indicator is inaccurate, you can adjust its readings within 3° in either direction.

If the air temperature shown on the display is close to 0 °C, this may indicate possible ice formation on the road surface. In this case, a warning symbol is displayed on the multi-information display: