Audio System (Vehicles Equipped with GPS) - Cassette Tape Playback

Cassette Tape Playback (optional equipment on some versions)

The cassette player can be used with the ignition key in the following positions: ACCESSORY (I) and ON (II). Insert the cassette into the loading slot with the side of the cassette showing the exposed magnetic tape facing right.

The cassette is then automatically loaded into the playing position and playback begins.

The track indicator is shown on the audio unit display. If the triangle point is facing up, the upper track of the cassette will play. To immediately change the tape track and reverse the direction of tape movement, press preset button 5 (). After one side of the cassette has finished playing, the player automatically switches to playback of the second track.

You cannot use the audio system control buttons located on the navigation system control panel. Audio system settings will only be shown on the side display.

Since text data cannot be displayed on the side display, you will only see the disc and track (or file) numbers.

When a cassette is loaded, the Dolby* noise reduction system is switched on automatically. The indicator will appear on the display. If the cassette was recorded without the Dolby system, the Dolby system should be turned off by pressing the NR button. The Dolby system will remain off until this button is pressed again.

* Dolby noise reduction system is manufactured under license from Dolby Laboratories Licensing Corporation. "Dolby" and the double-D symbol— is a registered trademark of Dolby Laboratories Licensing Corporation.