Replacing Bulbs and Fuses

PROCEDURE

1. If one of the headlights, parking lights or a brake light is not working, the most likely cause is a burned-out bulb. For bulb replacement, refer to subsection 14.

5. If both brake lights are not working, the cause is a faulty switch.

2. If several warning lamps, headlights, parking lights or tail lights are not working, a fuse has blown or the wiring is faulty (see subsection 14.3). The fuses are located in the block on the instrument panel on the driver's side.

3. Additional fuses and relays are located in the engine compartment fuse boxes on the right and left sides.

4. To replace a fuse, open the cover by releasing the latches. Pull the built-in plastic fuse puller and remove the fuse. Install a new fuse with the same current rating as the original. Determine and correct the cause of the blown fuse.

Recommended Lubricants and Fluids

GENERAL INFORMATION

Engine Oil: All-season engine oil, SAE 10W/40 to 20W/50, or API SG/CD or better. Engine Coolant: Ethylene glycol antifreeze mixed with water, low in salts. Manual Transmission: Hypoid gear oil, SAE 80W to API GL-4. Automatic Transmission: Dexron type II automatic transmission fluid. Brake Fluid: SAE J1703F or DOT4 brake fluid. Power Steering Fluid: Dexron II automatic transmission fluid. Tire Pressure, cold (atm): – Sedan and hatchback: • 155 SR13: 2.2 (front), 2.0 (rear) • 175/70 R13 82H: 2.2 (front), 2.0 (rear) – Coupe: • 175/65 R14 82H: 2.2 (front), 2.0 (rear)