Windshield and Rear Window Wiper and Washer Operation

Operating the Windshield Wipers and Washer (Type A)
1. Single-wipe mode
2. Low speed
3. High speed
4. Washer operation

To operate the wipers, move the lever to the desired position. To operate the washer, press the button (4) on the end of the lever. The ignition switch must be in the On position.
To use single-wipe operation (when driving in fog), move the lever to the MIST position and release it. If the washer does not operate, check the washer fluid level in the reservoir.
For instructions on filling the reservoir, refer to Section 2.3. In cold weather, turn on the rear window defogger before operating the washer. This prevents icing, which impairs visibility.
Do not operate the wipers on a dry windshield, as the blades may scratch the glass.

Operating the Windshield Wipers and Washer (Type B)
1. Intermittent wiper mode
2. Low speed
3. High speed
4. Washer operation

To operate the wipers, move the lever to the desired position. To operate the
washer, press the button (4) on the end of the lever.
The ignition switch must be in the On position.
To use intermittent wiper operation, move the lever to the INT position.

Operating the Windshield Wipers and Washer (Type C)
1. Single-wipe mode
2. Intermittent wiper mode
3. Low speed
4. High speed
5. Washer operation

To operate the wipers, move the lever to the desired position.
To operate the washer, press the button (5) on the end of the lever.
The ignition switch must be in the On position.
To use intermittent wiper operation, move the lever to the INT position.
To use single-wipe operation when driving in fog, pull the lever toward you and release it.
In addition, after the washer is activated, the wipers will automatically cycle twice even if the lever is in the Off position.

Operating the Rear Window Wiper and Washer
1. Washer and wiper operation together
2. Rear wiper operation (normal mode)
3. Rear wiper operation (intermittent mode)
4. Rear washer operation

To operate the wiper and washer, turn the knob on the end of the lever to the desired position.
The ignition switch must be in the On position.
When the lever is in the INT position, the rear wiper operates in intermittent mode.
The washer operates when the knob is held at either of the two end positions. When released, the knob automatically returns from these positions.

Headlight Washer

To wash the headlights, turn on the headlights and press the button.
The ignition switch must be in the On position.
Periodically check the fluid level in the reservoir through the transparent wall.
Refill with windshield washer fluid.

* Do not operate the headlight washer when the reservoir is empty, otherwise
the electric motor may overheat.