Honda Accord Quiz
Suspension and Steering

Removal and Installation of Front Suspension Thrust Arm

In this manual: Suspension and Steering
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

PROCEDURE

1. Loosen the wheel nuts of the corresponding front wheel. Raise the front of the vehicle and support it on safety stands. Remove the wheel.
2. Remove the plug from the plastic splash shield.

3. Отдайте гайку крепления переднего конца толкающей штанги к передней поперечной

3. Loosen the nut securing the front end of the thrust arm to the front crossmember.

4. Выверните болты крепления заднего конца штанги к нижнему рычагу подвески,

4. Remove the bolts securing the rear end of the arm to the lower control arm, then remove the thrust arm.

5. Install in the reverse order. Make sure all fasteners are tightened to the specified torque.
6. Take the vehicle to a specialized shop to check and adjust the front wheel alignment angles.

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.