Honda Accord Quiz
Suspension and Steering

Removal and Installation of Rear Stabilizer Bar

In this manual: Suspension and Steering
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

PROCEDURE

1. Loosen the wheel nuts. Raise the rear of the vehicle and support it on safety stands. Remove the rear wheels.

2. Отдайте гайки крепления к штанге нижних концов ее стоек.

2. Remove the nuts securing the lower ends of the stabilizer bar links to the bar.

3. Также выверните болты хомутов крепления опорных втулок штанги к днищу автомобиля.

3. Remove the bolts of the bushing retainer clamps securing the stabilizer bar bushings to the underbody. Remove the stabilizer bar.

4. Remove the clamps from the bushings and inspect the bushings for hardening or aging of the rubber. Replace defective bushings. Also check the ball joints in the stabilizer links for secure fit. Replace defective components.
5. Install in the reverse order of removal.

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.