Honda Accord Quiz
Suspension and Steering

Removal and Installation of Front Lower Control Arm

In this manual: Suspension and Steering
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

PROCEDURE

1. Loosen the wheel nuts of the corresponding front wheel. Raise the vehicle and support it on safety stands. Remove the wheel.
2. Remove the through bolt and disconnect the damper fork from the lower control arm assembly (see Removal and Installation of Front Coil Spring Strut Assembly).
3. Disconnect the thrust arm from the lower control arm (see Removal and Installation of Front Suspension Thrust Arm).
4. Disconnect the stabilizer bar link from the lower control arm (see Removal and Installation of Front Stabilizer Bar).

5. Извлеките шплинт и ослабьте корончатую гайку шарового пальца опоры нижнего

5. Remove the cotter pin and loosen the castellated nut of the lower arm ball joint stud. Do not remove the nut completely yet. Using a 2-jaw puller, separate the arm from the ball joint secured in the steering knuckle. Then remove the castellated nut completely.

6. Выверните осевой болт с внутренней стороны нижнего рычага управления). Снимите

6. Remove the through bolt from the inner side of the lower control arm. Remove the arm.

7. Install in the reverse order. Be sure to replace the cotter pin securing the ball joint castellated nut (see Note to Step 3 of Removal and Installation of Steering Knuckle).

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.