Honda Accord Quiz
Suspension and Steering

Power Steering Pump Removal and Installation

In this manual: Suspension and Steering
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

PROCEDURE

1. To minimize hydraulic fluid loss, pinch off the supply hose of the power steering pump.
2. On V6 models, remove the intake manifold cover.

3. Отсоедините от насоса подающий шланг и напорную линию. Обратите внимание на

3. Disconnect the supply hose and the pressure line from the pump. Note the difference between the supply and pressure line hoses: the first is secured to the pump by a spring-type clamp, while the fitting of the second has two bolts. To prevent dirt from entering the system, immediately plug the open ends of the disconnected lines.

1 — Pressure line bolts
2 — Supply line clamp
3 — Adjusting bolt

1 — Болты напорной линии

1 — Pressure line bolts
2 — Supply line clamp

4. Выверните крепежный и регулировочный болты рулевого насоса. Снимите насос.

4. Remove the mounting bolt and adjusting bolt of the power steering pump. Remove the pump.

5. Install in the reverse order of removal. When connecting the pressure line, replace the fitting O-ring. Upon completion, be sure to bleed air from the steering system (refer to Air Removal from the Power Steering Hydraulic System) and adjust the drive belt tension (refer to Maintenance and Adjustments).

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.