Honda Accord Quiz
Body Electrical Equipment

Instrument Cluster Removal and Installation

In this manual: Body Electrical Equipment
Owner's Manual — 80Maintenance and Adjustments — 43Four-Cylinder Engines — 27V6 Engines — 34Engine General Overhaul and Major Repair — 35Cooling and Heating Systems — 29Fuel and Exhaust Systems — 21Engine Electrical Equipment — 23Engine Control — 315-speed manual transmission (MT) — 74-speed automatic transmission (AT) — 14Clutch and Drive Shafts — 22Brake System — 23Suspension and Steering — 31Body — 41Body Electrical Equipment — 36Electrical Circuit Diagrams — 11
~1min read

The vehicles covered by this Manual are equipped with a Supplemental Restraint System (SRS). Before performing any work near the airbag module, steering column or instrument panel, disable the SRS to avoid injury from accidental deployment (see Section Airbags - General Information). SRS wiring can be easily identified by its yellow insulation.

PROCEDURE

1. Disconnect the negative battery cable first, then the positive cable.

If the vehicle's audio system is equipped with an anti-theft code, make sure you have the correct code to activate the audio system before disconnecting the battery!
2. Remove the instrument panel trim (see Chapter Body).
3. Remove the mounting screws, carefully remove the instrument cluster from its opening in the panel, and disconnect the electrical connectors from the rear of the assembly.

4. Установка производится в обратном порядке. Не забудьте подключить батарею

4. Installation is performed in the reverse order. Be sure to reconnect the battery (positive cable first, then negative).

Test yourself

A quick Honda Accord quiz: every answer comes with an explanation and a link to the manual page.