Single-Use Parts
Fender
In this manual: Single-Use Parts
10steps
~60min
3/5difficulty
Done 0 of 10
Contents:
Removal and Installation
Replacement
- Remove the front bumper assembly. (Refer to Front Bumper - "Front Bumper Assembly")
- Remove the A pillar garnish. (Refer to Body Side Molding - "A Pillar Garnish")
- Remove the front wheel guard. (Refer to Body Side Molding - "Front Wheel Guard")
- Remove the fender garnish. (Refer to Body Side Molding - "Fender Garnish")
- Remove the head lamps. (Refer to Body Electrical System - "Head Lamps")
- Remove the side repeater lamp [Fender]. (Refer to Body Electrical System - "Turn Sinal Lamp")
- Remove the fender apron cover (A) after removing the clips.

- Remove the front bumper side mounting bracket (A) after removing the bolts.
Tightening torque : 3.9 - 5,9 N·m (0.4 - 0.6 kgf·m, 2.9 - 4.3 lb·ft, 34.7 - 52.1 lb·in)

- Remove the fender insulator (A) after removing the clips.

- Remove the fender assembly (A) after removing the bolts.
Tightening torque : 6.9 - 8,8 N·m (0.7 - 0.9 kgf·m, 5.1 - 6.5 lb·ft, 60.8 - 78.1 lb·in)

Installation
- Install in reverse order of removal.
Was this page helpful?