Kia Stinger CK Quiz
Engine Control System/Fuel System

Purge Control Solenoid Valve (PCSV)

In this manual: Engine Control System/Fuel System
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
8steps
~48min
2/5difficulty
Done 0 of 8

Specifications

Specification

Item Specification
Coil Resistance (Ω) 18,5–22,5 [20 °C]

Description and Operation

Description

The purge control solenoid valve (PCSV), installed on the expansion tank, controls the passage between the canister and the intake manifold. This solenoid valve opens when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapor stored in the canister is delivered to the intake manifold.

Circuit Diagrams

Wiring Diagram

Harness Connector

Repair Procedures

Inspection

  1. Turn the ignition off.

  2. Disconnect the PCSV connector.

  3. Measure the resistance between terminals 1 and 2 of the PCSV.

  4. Make sure the resistance is within specification.

    Specification: 22.0–26.0 Ω [20 °C]

Removal

  1. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.

  2. Remove the engine cover.

    (Refer to Engine Mechanical System - Engine Cover)

  3. Disconnect the purge control solenoid valve connector (A).

  4. Disconnect the vapor hoses (B) from the purge control solenoid valve.

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.