Transmission & Driveline
P0605 Control Module Rom
In this manual: Transmission & Driveline
2steps
~12min
1/5difficulty
Done 0 of 2
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | |
| P0605 | CONTROL MODULE ROM [Internal Control Module Read Only Memory (ROM) Error] |
Diagnosis condition | When turning ON the ignition switch |
| Signal | — | ||
| Threshold | TCM ROM area sum parity check detects malfunction in ROM. | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
TCM
FAIL-SAFE
Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>GO TO 2.
CHECK DTC DETECTION
Turn ignition switch ON and wait 1 seconds or more.
Check the DTC.
Is “P0605” detected?
YES>>Go to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
CHECK INTERMITTENT INCIDNT
Refer to Intermittent Incident.
Is the inspection result normal?
YES>>Replace the TCM. Refer to Removal and Installation.
NO>>Repair or replace malfunctioning parts.
Was this page helpful?