Transmission & Driveline

P1588 Decel G Sensor

7steps
~42min
3/5difficulty
Done 0 of 7
DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P1588

G SENSOR

(Decel G Sensor Performance)
Diagnosis condition Power supply voltage ≥ 10 V
Signal Decel G sensor signal
Threshold

When the all of the following conditions a) to b) are satisfied twice in the same DC, DTC is detected

a) | Variation of acceleration/deceleration | ≥ 0.0273 G

b) | Variation of G after passing Filter | ≦ 0.011 G : Continue for 1 sec
Diagnosis delay time 5 seconds × 2 count

POSSIBLE CAUSE

  • Decel G sensor

  • ABS actuator and electric unit (control unit)

  • Harness or connector (CAN communication line is error)

FAIL-SAFE

Idle stop is not performed

DTC CONFIRMATION PROCEDURE

PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10 V.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Start the engine.

  2. Select “Data Monitor” in “TRANSMISSION”.

  3. Select “G SPEED”.

  4. Drive the Nissan Murano vehicle and maintain the following conditions for 10 seconds or more.

    Selector lever : “D” position
    Vhiecle speed : More than 1 km/h
    G SPEED : 0.05 G or more
  5. Stop the Nissan Murano vehicle.

  6. Repeat steps 4 through 5.

  7. Check the DTC.

Is DTC detected?

YES>>

Proceed to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC (ABS)

With CONSULT

Check “Self Diagnostic Results” in “ABS”.

Is any DTC detected?

YES>>

Check DTC detected item. Refer to DTC Index.

NO>>

WORK END