U0122 Lost Communication (vdc)
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | |
| U0122 | LOST COMM (BRAKE C/U) (Lost Communication With Nissan Murano Vehicle Dynamics Control Module) |
Diagnosis condition | When the ignition switch is ON |
| Signal | CAN communication signal | ||
| Threshold | TCM is unable to receive the CAN communications signal from ABS actuator and electric unit (control unit) | ||
| Diagnosis delay time | Continuously for 2 seconds or more | ||
POSSIBLE CAUSE
ABS actuator and electric unit (control unit)
Harness or connector (CAN communication line is open or shorted)
FAIL-SAFE
Not changed from normal driving
DTC CONFIRMATION PROCEDURE
CHECK DTC PRIORITY
WhenDTC U0122 is displayed together with DTC U0300, diagnose first the DTC U0300.
Is "U0300" detected?
YES>>Perform diagnosis of DTC U0300. Refer to Diagnosis Procedure.
NO>>GO TO 2.
PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>>GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
Ignition switch ON and wait for at least 2 seconds.
Check the DTC.
Is DTC detected?
YES>>Proceed to Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: INSPECTION END
For the diagnosis procedure, refer to Trouble Diagnosis Flow Chart.