Transmission & Driveline

P0741 Torque Converter

12steps
~72min
3/5difficulty
Done 0 of 12
DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P0741

TORQUE CONVERTER

(Torque Converter Clutch Circuit Performance/Stuck Off)
Diagnosis condition

When all of the following conditions are satisfied:

  • TCM power supply voltage: More than 11 V

  • LU pressure: More than 0.2 MPa

Signal —
Threshold Torque converter slip speed: (40+vihicle speed/2) rpm
Diagnosis delay time Maintained for 30 seconds

POSSIBLE CAUSE

  • Torque converter clutch solenoid valve

  • Control valve assembly

  • Torque converter

FAIL-SAFE

  • Start is slow

  • Acceleration is slow

  • Lock-up is not performed

DTC Confirmation Procedure

PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>>

GO TO 2.

PREPARATION BEFORE OPERATION

With CONSULT

  1. Start the engine.

  2. Select “Data Monitor” in “TRANSMISSION”.

  3. Select “FLUID TEMP”.

  4. Confirm that the CVT fluid temperature is in the following range.

    FLUID TEMP : 20 °C or more

With GST

  1. Start the engine.

  2. Set the CVT fluid to 20 °C or more.

Is the CVT fluid 20 °C or more?

YES>>

GO TO 3.

NO>>
  1. Warm the transaxle.

  2. GO TO 3.

CHECK DTC DETECTION

  1. Drive the Nissan Murano vehicle.

  2. Maintain the following conditions for 30 seconds or more.

    Selector lever : “D” position
    Accelerator pedal position : 0.5/8 or more
    Nissan Murano Vehicle speed : 40 km/h or more
  3. Stop the vehicle.

  4. Check the first trip DTC.

Is “P0741” detected?

YES>>

Go to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK INTERMITTENT INCIDNT

Refer to Intermittent Incident.

Is the inspection result normal?

YES>>

Replace transaxle assembly. Refer to Removal and Installation (front wheel drive) or Removal and Installation (all wheel drive).

NO>>

Repair or replace the malfunction items.