Transmission & Driveline
P0894 Transmission Component Slipping
In this manual: Transmission & Driveline
3steps
~18min
2/5difficulty
Done 0 of 3
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P0894 | T/M COMPONENT SLIPPING (Transmission component slipping) |
Diagnosis condition | Constant Nissan Murano vehicle speed on the flat road | |
| Signal | — | |||
| Threshold | CVT gear ratio: 0.498 less than | |||
| Diagnosis delay time | 30 seconds | |||
POSSIBLE CAUSE
Pulley
Chain belt
FAIL-SAFE
Not changed from normal driving
PRECONDITIONIG
If “DTC CONFIRMATION PROCEDURE” is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
>>GO TO 2.
CHECK DTC DETECTION
Start the engine.
Drive the Nissan Murano vehicle at constant vehicle speed on the flat load for 30 seconds or more.
Check DTC
Is “P0894” detected?
YES>>Go to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
REPLACE TRANSAXLE ASSEMBLY
Replace the transaxle assembly. Refer to Removal and Installation (front wheel drive) or Removal and Installation (all wheel drive).
YES>>WORK END
Was this page helpful?