Transmission & Driveline

U0100 Lost Communication (ecm A)

2steps
~12min
1/5difficulty
Done 0 of 2
DTC Description

DTC DETECTION LOGIC

When the ignition switch is ON, TCM is unable to receive the CAN communications signal from ECM continuously for 2 seconds or more.

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U0100

LOST COMM (ECM A)

(Lost Communication With ECM/PCM A)
Diagnosis condition When the ignition switch is ON
Signal CAN communication signal
Threshold TCM is unable to receive the CAN communications signal from ECM
Diagnosis delay time Continuously for 2 seconds or more

POSSIBLE CAUSE

  • ECM

  • Harness or connector (CAN communication line is open or shorted)

FAIL-SAFE

  • Selector shock is large

  • Start is slow

  • Acceleration is slow

  • Lock-up is not performed

DTC Confirmation Procedure

CHECK DTC PRIORITY

WhenDTC U0100 is displayed together with DTC U0300, diagnose first the DTC U0300.

Is "U0300" detected?

YES>>

Perform diagnosis of DTC U0300. Refer to Diagnosis Procedure.

NO>>

GO TO 2.

PREPARATION BEFORE WORK

If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Start the engine and wait for at least 5 seconds.

  2. Check the DTC.

Is “U0100” detected?

YES>>

Go to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

For the diagnosis procedure, refer to Trouble Diagnosis Flow .