P0746 Pressure Control Solenoid a
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P0746 | PC SOLENOID A (Pressure Control Solenoid A Performance/Stuck Off) |
1 | Diagnosis condition | When all of the following conditions are satisfied:
|
| Signal | — | |||
| Threshold | The following condition is detected twice or more (1 second or more later after detection of the first) in the same DC
|
|||
| Diagnosis delay time | — | |||
| 2 | Diagnosis condition | When all of the following conditions are satisfied:
|
||
| Signal | — | |||
| Threshold | The following condition is detected twice or more (1 second or more later after detection of the first) in the same DC
|
|||
| Diagnosis delay time | — | |||
POSSIBLE CAUSE
Line pressure solenoid valve
Control valve assembly
FAIL-SAFE
Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed
PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>>GO TO 2.
CHECK DTC DETECTION
Start the engine.
Drive the Nissan Murano vehicle.
Maintain the following conditions for 10 seconds or more.
Selector lever : “D” position Accelerator pedal position : 0.5/8 or more Nissan Murano Vehicle speed : 40 km/h or more Stop the vehicle.
Check the first trip DTC.
Is “P0746”detected?
YES>>Go to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
CHECK INTERMITTENT INCIDNT
Refer to Intermittent Incident.
Is the inspection result normal?
YES>>Replace transaxle assembly. Refer to Removal and Installation (front wheel drive) or Removal and Installation (all wheel drive).
NO>>Repair or replace the malfunction items.