Transmission & Driveline
P0863 Tcm Communication
In this manual: Transmission & Driveline
2steps
~12min
1/5difficulty
Done 0 of 2
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | |
| P0863 | CONTROL UNIT (CAN) (TCM Communication Circuit) |
Diagnosis condition | Engine is started |
| Signal | — | ||
| Threshold | An error is detected at the initial CAN diagnosis of TCM | ||
| Diagnosis delay time | Within 1 second | ||
POSSIBLE CAUSE
TCM
FAIL-SAFE
Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed
PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>>GO TO 2.
CHECK DTC DETECTION
Start the engine.
Check the DTC.
Is “P0863” detected?
YES>>Go to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
CHECK INTERMITTENT INCIDNT
Refer to Intermittent Incident.
Is the inspection result normal?
YES>>Replace TCM. Refer to Removal and Installation.
NO>>Repair or replace malfunctioning parts.
Was this page helpful?