Audio / Video

AV Signal Stop (Low Battery Voltage) (B158F)

~2min read

DESCRIPTION

This DTC is stored when an audio or video signal is interrupted due to a temporary drop in battery voltage input to the radio and display assembly.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

B158F

AV Signal Stop (Low Battery Voltage)

A video or audio signal is interrupted when battery voltage drops

  • Radio and Display Receiver Assembly
  • Wire harness or connector

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts replaced during inspection or maintenance of the vehicle, initialization, registration or calibration may be required. Refer to the precautions for the audio and visual system.

    Click here

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly that was installed in another vehicle is reused, the following may occur:
    • A communication malfunction DTC is stored.
    • The radio and display receiver assembly may not operate normally.
  • Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK VEHICLE SIGNAL (OPERATION CHECK)

(a) Select the "Vehicle Signal Check Mode" screen. Refer to Vehicle Signal Check in Operation Check.

Click here

(b) Measure the battery voltage.

Standard voltage:

11 à 14 V

HINT:

This screen is updated every second.

NG

GO TO STEP 3

OK
  1. CHECK DTCs

(a) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(b) Check DTCs again and confirm that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTC is output.

OK

END

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY ASSEMBLY POWER SOURCE)

(a) Disconnect the radio receiver and display assembly connector.

*a

Front view of wire harness side connector

(to radio receiver and display assembly)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F129-4 (+B1) - Body ground

Always

11 à 14 V

OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR