Audio / Video
Voice recognition not possible
In this manual: Audio / Video
~1min read
PROCEDURE
CHECK CONDITION
(a) Paying attention to the status of the voice command, perform a voice recognition operation.
OK:
The voice command is recognized normally.
HINT:
- When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the microphone icon. (Example: When "Cancel" is spoken, "Cancel" is displayed in the voice recognition result display area.)
- If an unnecessary word (such as "Hum" or "Ah") is spoken before or after the recognition word, the system will not recognize the recognition word correctly.
- The system cannot recognize voice commands when multiple people speak at the same time.
- If the speaking speed is too fast or too slow, the recognition rate may decrease.
- The system may have difficulty recognizing voice commands depending on the sound quality (such as a hoarse voice due to poor physical condition).
| OK | END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SOUND CONDITION) |
| NG | GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE |
Was this page helpful?