Audio / Video

Radio Receiver Power Supply Circuit

~1min read

DESCRIPTION

This is the power supply circuit that operates the Radio Receiver and Display Assembly.

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY ASSEMBLY POWER SOURCE)

(a) Disconnect the connectors of the Radio Receiver and Display Assembly.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F129-1 (GND1) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Ignition switch position

Specified Condition

F126-4 (+B1) - F129-1 (GND1)

Always

11 à 14 V

F129-15 (ACC1) - F129-1 (GND1)

Ignition Switch in ACC position

11 à 14 V

F131-19 (IG) - F129-1 (GND1)

Ignition Switch in ON position

11 à 14 V

*a

Front view of wire harness side connector

(to radio receiver and display assembly)

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR