Audio / Video

USB Device Malfunction (B1585)

~3min read

DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

B1585

USB Device Malfunction

USB Device Malfunction

  • Storage class other than mass storage or USB device with incompatible protocol
  • USB device with incompatible file system, or corrupted or incompatible file allocation table
  • "iPod" Malfunction
  • "iPod" with unsupported firmware
  • Unsupported "iPod" model
  • USB Device or "iPod"
  • Radio and Display Receiver Assembly
DTC Detection Conditions

Vehicle Operating Conditions

Sequence 1

Sequence 2

Sequence 3

Sequence 4

Sequence 5

Diagnostic Condition

-

-

-

-

-

-

Malfunction Status

A USB device with a storage class other than mass storage, or with an incompatible protocol, is connected

○

-

-

-

-

A USB device with an incompatible file system, or a corrupted or incompatible file allocation table, is connected

-

○

-

-

-

"iPod" Malfunction

-

-

○

-

-

An "iPod" with unsupported firmware is connected

-

-

-

○

-

An unsupported "iPod" model is connected

-

-

-

-

○

Detection Duration

-

-

-

-

-

Number of Trips

1 trip(s)

1 trip(s)

1 trip(s)

1 trip(s)

1 trip(s)

HINT:

The DTC is output when the conditions for any one of the sequences in the table above are met.

PRECAUTION / NOTICE / HINT

NOTICE:

  • Depending on the parts replaced during inspection or maintenance of the vehicle, initialization, registration or calibration may be required. Refer to the precautions for the audio and visual system.

    Click here

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly that was installed in another vehicle is reused, the following may occur:
    • A communication malfunction DTC is stored.
    • The radio and display receiver assembly may not operate normally.

PROCEDURE

  1. REPLACE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

(b) Turn the ignition switch OFF.

HINT:

When this DTC has been stored, it is necessary to turn the ignition switch OFF so that the vehicle can recognize a new device when it is connected.

(c) Turn the ignition switch to ACC.

(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:

  • If the malfunction occurred while a USB device was being used, use a different USB device to perform the check. If the malfunction occurred while an "iPod" was being used, use a different "iPod" to perform the check.
  • Refer to the System Description section for compatible formats and versions.

    Click here

NEXT
  1. CHECK DTCs

(a) Clear the DTCs.

Click here

Body Electrical > Navigation System > Clear DTCs

(b) Check DTCs again and confirm that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTC is output.

OK

INCOMPATIBLE USB DEVICE FORMAT, INCOMPATIBLE "iPod" VERSION, OR MALFUNCTIONING USB DEVICE OR "iPod"

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY