Steering Pad Switch Circuit
DESCRIPTION
This circuit sends an activation signal from the steering pad switch assembly to the radio receiver and display assembly.
If the circuit is open, the audio system cannot be controlled by the steering pad switch assembly.
In the event of a short circuit, the result is the same as keeping a switch pressed continuously. Therefore, the radio receiver and display assembly cannot be activated by the steering pad switch assembly, and the radio receiver and display assembly itself cannot operate.
WIRING DIAGRAM
PRECAUTION / NOTICE / HINT
NOTICE:
This vehicle is equipped with a Supplemental Restraint System (SRS) including components such as airbags. Before performing any service (including removal or installation of parts), carefully read the precautions for the Supplemental Restraint System.
Click here![]()
PROCEDURE
INSPECT WIRE HARNESS AND CONNECTOR (STEERING PAD SWITCH SIGNAL)
(a) Disconnect connector F129 from the radio receiver and display assembly.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
F129-21 (SW1) - F129-24 (SWG) |
No switch pressed |
95 to 105 kΩ |
SEEK+ switch pressed |
Less than 2.5 Ω |
|
SEEK- switch pressed |
313 à 345 Ω |
|
VOL+ switch pressed |
950 à 1 050 Ω |
|
VOL- switch pressed |
2 955 à 3 265 Ω |
|
F129-22 (SW2) - F129-24 (SWG) |
No switch pressed |
95 to 105 kΩ |
MODE switch pressed |
Less than 2.5 Ω |
|
On-hook switch pressed |
313 à 345 Ω |
|
Off-hook switch pressed |
950 à 1 050 Ω |
|
VOICE switch pressed |
2 955 à 3 265 Ω |
| OK | GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE |
|
CHECK STEERING PAD SWITCH ASSEMBLY
(a) Remove the steering pad switch assembly.
Click here![]()
(b) Check the steering pad switch assembly.
Click here![]()
| NG | REPLACE STEERING PAD SWITCH ASSEMBLY |
|
CHECK SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
(a) Remove the spiral cable with sensor sub-assembly.
Click here![]()
(b) Check the spiral cable with sensor sub-assembly.
Click here![]()
NOTICE:
- Hold down the lock on the center section of the spiral cable with sensor sub-assembly to rotate the spiral cable with sensor sub-assembly.
- The spiral cable with sensor sub-assembly is a critical part of the SRS airbag system. Incorrect removal or installation of the spiral cable with sensor sub-assembly may prevent the airbag from deploying.
- If the spiral cable with sensor sub-assembly may break, do not rotate the spiral cable with sensor sub-assembly beyond the specified value.
| OK | REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - CLOCK SPRING SUB-ASSEMBLY WITH SENSOR OR BODY GROUND) |
| NG | REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |