Loss of Communication with Combination Meter (B1324)
DESCRIPTION
This DTC is stored when a communication error occurs between the radio and display assembly and the combination meter assembly.
DTC No. | Detection Item | DTC Detection Condition | Suspected Area |
|---|---|---|---|
B1324 |
Loss of communication with combination meter |
After the radio and display assembly receives an information record signal sent from the combination meter assembly when the ignition switch is ON at least 1 time, the radio and display assembly does not receive the signal for at least 30 seconds |
|
WIRING DIAGRAM
PRECAUTION / NOTICE / HINT
NOTICE:
- Depending on the parts replaced during inspection or maintenance of the vehicle, initialization, registration or calibration may be required. Refer to the precautions for the audio and visual system.
Click here
.gif)
- When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly that was installed in another vehicle is reused, the following may occur:
- A communication malfunction DTC is stored.
- The radio and display receiver assembly or navigation ECU may not operate correctly.
PROCEDURE
CHECK DTCs (METER/GAUGE SYSTEM)
(a) Clear the DTCs.
Body Electrical > Combination Meter > Trouble Codes(b) Check DTCs again and confirm that no DTCs are output.
Body Electrical > Combination Meter > Clear DTCsOK:
No DTC is output.
| NG | GO TO METER/GAUGE SYSTEM |
|
CHECK WIRE HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)
(a) Disconnect the F131 connector from the radio and display receiver assembly.
(b) Disconnect the combination meter assembly connector F4.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
F131-5 (CNH1) - F4-36 (MSCH) |
Always |
Below 1 Ω |
F131-6 (CNL1) - F4-37 (MSCL) |
Always |
Below 1 Ω |
F131-5 (CNH1) - Body ground |
Always |
10 kΩ minimum |
F131-6 (CNL1) - Body ground |
Always |
10 kΩ minimum |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
REPLACE COMBINATION METER ASSEMBLY
(a) Replace the combination meter assembly.
Click here![]()
(b) Clear the DTCs.
Click here![]()
(c) Check DTCs again and confirm that no DTCs are output.
Body Electrical > Combination Meter > Clear DTCsOK:
No DTC is output.
| OK | END |
| NG | REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |