Steering Tie Rod Ends

Tie rod end A. EQUAL DISTANCES.

B. STEERING KNUCKLE ARM, STRUT SUSPENSION.

30. ADJUSTING SCREW.

31. TIE ROD END (LEFT).

33. NUT.

34. CLAMP BOLT.

35. TIE ROD (LEFT)

Remove or disconnect:

PROCEDURE.

1. Unscrew the ball stud nut..

2. Loosen the clamp bolts

34..

3. Using puller KM-507B, disconnect end 31 or 41 with the ball stud

from the corresponding front suspension strut steering knuckle arm..

4. Remove end 31 or 41 from the adjusting screw

30..

Installation

PROCEDURE.

1. Screw end 31 or 41 onto the adjusting screw

30..

2. Connect the ball stud of the end to the steering knuckle arm..

3. Screw nut 33 onto the ball stud. Tighten the tie rod ball stud nut.

torque 60–75 N·m..

Adjust..

PROCEDURE.

1. Adjust the front wheel toe-in by turning adjusting screw 30.

2. Tighten the tie rod clamp bolt to torque 22 N·m.