Tie Rods

Remove or disconnect:

PROCEDURE.

1. Remove locking plate 37 from the bolt heads

38. Discard the plate..

2. Bolt 38 securing the inner tie rod joint. If one tie rod is removed, pull the head of this rod out from the space between support plate 39 and washer 29 and remove the rod. When both tie rods are removed simultaneously, after removing the first rod, reinstall bolt 38 in place to maintain the relative position of the rack, boot 44 and guide plate 28..

3. Loosen the clamp bolt..

4. Remove the tie rod..

Install or connect

Installation of tie rods A. SLOT POSITION OF PLATE DURING INSTALLATION.

29. WASHER.

35. TIE ROD (LEFT).

37. LOCKING PLATE.

38. BOLT.

39. SUPPORT PLATE.

40. TIE ROD (RIGHT).

44. HOUSING COVER

PROCEDURE.

1. Screw the adjusting screw into the rod. Tighten the clamp bolt.

tie rod to torque 22 N·m..

2. Insert into the recesses of boot 44 and center relative to the holes in the washer

29..

3. Insert bolts 38 into the holes of the support plate, then into bushings 36 of tie rod joints 35 and 40, into the holes of washers 29 and guide plate 28, which

is located inside the boot

44. Screw bolts 38 into the steering rack..

Tighten the tie rod mounting bolts to the steering rack to torque 90 N·m.

4. Install a new locking plate onto the heads of bolts 38

37. Note

the correct position of the plate slots.