Active Noise Control Microphone
Components
COMPONENTS
ILLUSTRATION
*1 |
ACTIVE NOISE CONTROL MICROPHONE |
*2 |
ACTIVE NOISE CONTROL MICROPHONE WITH COVER |
*3 |
ROOF HEADLINING HOLDER COVER |
- |
- |
Installation
INSTALLATION
PROCEDURE
1. INSTALL ACTIVE NOISE CONTROL MICROPHONE
HINT:
Use the same procedure for all active noise control microphones.
(a) Engage the 2 claws to install the active noise control microphone to the roof headlining holder cover as shown in the illustration.
![]() |
Install in this Direction |
2. INSTALL ACTIVE NOISE CONTROL MICROPHONE WITH COVER
HINT:
Use the same procedure for all active noise control microphone with covers.
(a) Engage the 2 claws to install the active noise control microphone with cover as shown in the illustration.
![]() |
Install in this Direction |
(b) Connect the connector.
3. INSTALL ROOF HEADLINING ASSEMBLY
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during active noise control microphone removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane Departure Alert System (w/ Steering Control) |
|
Pre-collision System |
|||
Intelligent Clearance Sonar System* |
|||
Lighting System (for Gasoline Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking Assist Monitor System |
||
Panoramic View Monitor System |
|||
Front passenger seat |
Zero point calibration (Occupant classification system) |
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here ![]()
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model) Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane Departure Alert System (w/ Steering Control) |
|
Pre-collision System |
|||
Intelligent Clearance Sonar System* |
|||
Lighting System (for HV Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking Assist Monitor System |
||
Panoramic View Monitor System |
|||
Front passenger seat |
Zero point calibration (Occupant classification system) |
|
|
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here ![]()
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
Click here ![]()
2. REMOVE ACTIVE NOISE CONTROL MICROPHONE WITH COVER
HINT:
Use the same procedure for all active noise control microphone with covers.
(a) Disconnect the connector. |
![]() |
(b) Disengage the 2 claws to remove the active noise control microphone with cover as shown in the illustration.
![]() |
Remove in this Direction |
3. REMOVE ACTIVE NOISE CONTROL MICROPHONE
HINT:
Use the same procedure for all active noise control microphones.
(a) Disengage the 2 claws to remove the active noise control microphone from the roof headlining holder cover as shown in the illustration.
![]() |
Remove in this Direction |



