Television Camera(for Front)
Components
COMPONENTS
ILLUSTRATION
*A |
for Bar Type Radiator Grille |
*B |
for Mesh Type Radiator Grille |
*1 |
COOL AIR INTAKE DUCT SEAL |
*2 |
FRONT TELEVISION CAMERA ASSEMBLY |
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT TELEVISION CAMERA ASSEMBLY
(a) Engage the 2 guides.
(b) Install the front television camera assembly with the 2 screws.
(c) Connect the connector.
2. INSTALL COOL AIR INTAKE DUCT SEAL
Click here ![]()
3. PERFORM CALIBRATION
for Gasoline Model: Click here ![]()
for HV Model: Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front television camera assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
Front television camera assembly |
Front television camera view adjustment |
Panoramic View Monitor System |
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
Front television camera assembly |
Front television camera view adjustment |
Panoramic View Monitor System |
PROCEDURE
1. REMOVE COOL AIR INTAKE DUCT SEAL
Click here ![]()
2. REMOVE FRONT TELEVISION CAMERA ASSEMBLY
(a) Disconnect the connector. |
![]() |
(b) Remove the 2 screws. |
![]() |
(c) Disengage the 2 guides to remove the front television camera assembly.


