No Sound can be Heard from Speakers. Noise Occurs or Sound Skips when Portable Player Plays. Noise Occurs
No Sound can be Heard from Speakers
PROCEDURE
CHECK AUDIO SETTINGS
(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.
OK:
Audio system returns to normal.
HINT:
Sound quality adjustment measures vary according to the type of amplifier.
| OK | END |
| NG | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Noise Occurs or Sound Skips when Portable Player Plays
HINT:
- Perform this check with the portable player volume set at an appropriate level.
- Make sure that there are no obstructions between the portable player and the radio and display receiver assembly that may block signals, and that the portable player and the radio and display receiver assembly are not excessively far apart.
- Make sure that devices other than the radio and display receiver assembly are not connected to the portable player.
- Make sure that there is no interference from a wireless LAN, etc.
PROCEDURE
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL
(a) Check that the same problem does not occur in the sound heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.
OK:
The same problem does not occur in the sound heard from the speakers.
| NG | MALFUNCTION IN PORTABLE PLAYER |
|
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES
(a) Remove additional devices which use radio waves.
(b) Play the portable player and check that the same problem does not occur in the sound heard from the speakers.
OK:
The same problem does not occur in the sound heard from the speakers.
| OK | END |
| NG | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Noise Occurs
PROCEDURE
CHECK NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear left or right).
OK:
The location of the noise source can be determined.
| NG | GO TO STEP 3 |
|
CHECK SPEAKERS
(a) Check the installation condition of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation or other failures.
Result | Proceed to |
|---|---|
No malfunction is found. |
A |
A speaker is installed incorrectly. |
B |
Foreign matter is in a speaker. |
C |
A speaker cone paper is broken. |
D |
| B | REINSTALL SPEAKER |
| C | REMOVE FOREIGN MATTER |
| D | REPLACE SPEAKER |
|
CHECK NOISE CONDITIONS
(a) Check the noise condition.
HINT:
The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.
Condition under which Noise Occurs | Noise Source |
|---|---|
Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped. |
Generator |
Noise occurs during A/C or heater operation. |
Blower motor |
Noise occurs when the horn switch is pressed and released or when pressed and held. |
Horn |
Noise occurs synchronously with the turn signal blinking pattern. |
Flasher |
Noise occurs during window washer operation. |
Washer |
Noise occurs during wiper operation. |
Wiper |
Noise occurs when the brake pedal is depressed. |
Stop light switch |
Others |
Static electricity |
HINT:
- In the left column of the table, find the situation that matches the customer's complaint. Then, in the right column, find the part that is causing the noise. Check the respective noise filter.
- To save time and avoid a misdiagnosis, first make sure that the noise is not coming from outside the vehicle.
- Troubleshoot noises in descending order of loudness.
- Setting the radio to a frequency where no signal is received may make recognition of the noise problem easier.
Result | Proceed to |
|---|---|
The noise source cannot be determined. |
A |
The noise source can be determined. |
B |
| A | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| B | REPAIR OR REPLACE NOISE SOURCE |