Ultrasonic Sensor(for Front)
Components
COMPONENTS
ILLUSTRATION
*1 |
FRONT CENTER ULTRASONIC SENSOR |
*2 |
FRONT CORNER ULTRASONIC SENSOR |
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT CENTER ULTRASONIC SENSOR
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the front center ultrasonic sensor. |
|
2. INSPECT FRONT CORNER ULTRASONIC SENSOR
(a) for RH Side:
(1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the front corner ultrasonic sensor RH. |
|
(b) for LH Side:
(1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the front corner ultrasonic sensor LH. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT CORNER ULTRASONIC SENSOR
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
(a) Engage the 2 claws to install the front corner ultrasonic sensor as shown in the illustration.
![]() |
Install in this Direction |
(b) Connect the connector.
2. INSTALL FRONT CENTER ULTRASONIC SENSOR
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
(a) Engage the 2 claws to install the front center ultrasonic sensor as shown in the illustration.
![]() |
Install in this Direction |
(b) Connect the connector.
3. INSTALL FRONT BUMPER ASSEMBLY
Click here ![]()
4. PERFORM CALIBRATION
for Gasoline Model: Click here ![]()
for HV Model: Click here ![]()
SST: 09989-00020
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
|
|
|
|
Front bumper assembly (w/ Panoramic View Monitor System) |
Front television camera view adjustment |
Panoramic View Monitor System |
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
|
|
|
|
Front bumper assembly (w/ Panoramic View Monitor System) |
Front television camera view adjustment |
Panoramic View Monitor System |
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here ![]()
2. REMOVE FRONT CENTER ULTRASONIC SENSOR
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
(a) Disconnect the connector. |
![]() |
(b) Disengage the 2 claws and remove the front center ultrasonic sensor as shown in the illustration.
![]() |
Remove in this Direction |
3. REMOVE FRONT CORNER ULTRASONIC SENSOR
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
(a) Disconnect the connector. |
![]() |
(b) Disengage the 2 claws and remove the front corner ultrasonic sensor as shown in the illustration.
![]() |
Remove in this Direction |







