Television Camera(for Side)
Components
COMPONENTS
ILLUSTRATION
*1 |
OUTER MIRROR |
*2 |
OUTER MIRROR COVER |
*3 |
SIDE TELEVISION CAMERA ASSEMBLY |
*4 |
VISOR HOUSING |
*5 |
CAMERA COVER |
- |
- |
Installation
INSTALLATION
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL SIDE TELEVISION CAMERA ASSEMBLY
(a) Using a T10 "TORX" driver, install the side television camera assembly to the camera cover with the 2 screws.
(b) Engage the 3 guides as shown in the illustration.
![]() |
Install in this Direction |
(c) Engage the 4 claws.
(d) Engage the 3 guides.
(e) Connect the connector.
(f) Engage the clamp.
2. INSTALL VISOR HOUSING
Click here ![]()
3. INSTALL OUTER MIRROR COVER
Click here ![]()
4. INSTALL OUTER MIRROR
Click here ![]()
5. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER
Click here ![]()
6. PERFORM CALIBRATION
for Gasoline Model: Click here ![]()
for HV Model: Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side television camera assembly removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
|
Side television camera view adjustment |
Panoramic View Monitor System |
Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
|
Side television camera view adjustment |
Panoramic View Monitor System |
PROCEDURE
1. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER
Click here ![]()
2. REMOVE OUTER MIRROR
Click here ![]()
3. REMOVE OUTER MIRROR COVER
Click here ![]()
4. REMOVE VISOR HOUSING
Click here ![]()
5. REMOVE SIDE TELEVISION CAMERA ASSEMBLY
(a) Disengage the clamp. |
![]() |
(b) Insert a 0.9 mm (0.0354 in.) spark plug gap gauge or similar tool into the connector as shown in the illustration. NOTICE:
|
|
(c) Lift the claw and disconnect the connector.
(d) Disengage the 3 guides. |
![]() |
(e) Disengage the 4 claws. |
![]() |
(f) Disengage the 3 guides as shown in the illustration.
![]() |
Remove in this Direction |
(g) Using a T10 "TORX" driver, remove the 2 screws to remove the side television camera assembly from the camera cover. |
![]() |







