Audio, Visual, Telematics

Radio Receiver Power Source Circuit. Registered Device cannot be Deleted. Reverse Signal Circuit

~2min read

Radio Receiver Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)

(a) Disconnect the G3 and G2 radio and display receiver assembly connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G3-1 (GND1) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

G3-4 (+B1) - G3-1 (GND1)

Always

11 to 14 V

G3-15 (ACC1) - G3-1 (GND1)

Engine switch on (ACC)

11 to 14 V

G2-19 (IG) - G3-1 (GND1)

Engine switch on (IG)

11 to 14 V

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

Registered Device cannot be Deleted

PROCEDURE

  1. DELETE OPERATION

(a) Check if a registered portable player can be deleted normally.

OK:

Registered portable player can be deleted normally.

OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Reverse Signal Circuit

DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the BKUP LP relay.

WIRING DIAGRAM

PROCEDURE

  1. CHECK BACK-UP LIGHT

(a) Move the shift lever to R and check if the back-up lights come on.

OK:

The back-up lights come on.

NG

GO TO LIGHTING SYSTEM

OK
  1. CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

(a) Disconnect the G3 radio and display receiver assembly connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

G3-28 (REV) - Body ground

Engine switch on (IG)

Shift lever in R

11 to 14 V

G3-28 (REV) - Body ground

Engine switch on (IG)

Shift lever not in R

Below 1 V

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR