Acn Call End
ACN CALL END
ACN CALL END
This function cancels the ACN (Automatic Collision Notification) with the telematics service provider. After a collision during which the DCM receives the "Collision Detection Signal", the vehicle keeps sending the emergency call notification to the telematics service provider until the ACN Call End utility has been run or the backup battery (BUB) (depending on equipment) has discharged. Use the ACN Call End utility to cancel the ACN call.
NOTICE:
The BUB (Back-Up Battery) must not be replaced while an ACN call is in progress.
HINT:
Once the ACN Call End utility has been run, the backup battery (BUB) must be replaced.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn on the Techstream.
(d) Select "Telematics" on the System Selection Menu screen, then click "Utility".
(e) Click "DCM Service" on the Utility Selection Menu screen.
Body Electrical > Telematics > UtilityDCM Service
(f) Select "ACN call end", then click "Next" on the DCM Service Utility screen.
*a |
Example |
(g) Follow the instructions on the Techstream.