Mobile Communication

Unable To Connect To Call Center

~2min read

DESCRIPTION

This may occur when the phone's radio signal strength has been very weak, or if the Safety Connect system is malfunctioning and a DTC is set.

PROCEDURE

  1. CHECK COMMUNICATION SERVICE STATUS

(a) Move the vehicle.

(1) If the vehicle is outside a communication service area, move it into a communication service area, wait a few moments, and try the operation again.

OK:

The problem does not reoccur.

OK

END

NG
  1. CHECK DTCs

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON and wait for 10 seconds.

(d) Turn on the Techstream.

(e) Perform the "Health Check" and check the current DTCs.

Click here

Result:

Result

Proceed to

No DTCs are output

A

DTCs are output

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A
  1. CHECK DCM OPERATION HISTORY

(a) Check "DCM Operation History".

Click here

Result:

Result

Proceed to

Signal strength is weak (0 or 1)

A

Communication shows "Fail"

No problem with signal strength or communication

B

HINT:

If a communication problem occurred in the past but communication now works correctly, the cause may be temporary radio interference or the vehicle may have been outside the reception area.

B

END

A
  1. REPLACE DCM (DATA COMMUNICATION MODULE)

(a) Replace the DCM (telematics transceiver).

Click here

NOTICE:

  • The ignition switch must be in the OFF position.
  • Do not swap the DCM (telematics transceiver) with a DCM from another vehicle.
NEXT

PERFORM DCM ACTIVATION