Mobile Communication

DCM Power Source Circuit

~1min read

DESCRIPTION

This is the power source circuit of the DCM (telematics transceiver).

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK WIRE HARNESS AND CONNECTOR (DCM (TELEMATICS TRANSCEIVER) - BATTERY AND BODY GROUND)

(a) Disconnect connector F134 from the DCM (Data Communication Module).

*a

Front view of wire harness side connector

(to DCM (telematics transceiver))

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F134-4 (E) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

F134-1 (+B) - F134-4 (E)

Always

11 à 14 V

F134-7 (IG2) - F134-4 (E)

Ignition Switch in ON position

11 à 14 V

F134-8 (ACC) - F134-4 (E)

Ignition Switch in ACC position

11 à 14 V

OK

GO TO APPLICABLE SYSTEM AS INDICATED IN THE PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR