Mobile Communication

Backup Battery Malfunction (B15CC)

~2min read

DESCRIPTION

This DTC is stored when the DCM (telematics transceiver) detects any of the following conditions:

  • The voltage of the backup battery (BUB) drops or the backup battery (BUB) malfunctions.
  • The temperature of the backup battery (BUB) is (temporarily) high.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

B15CC

Back-Up Battery (BUB) Failure

Backup battery (BUB) malfunction

  • Backup battery (BUB)
  • DCM (Telematics Transceiver)

PRECAUTION / NOTICE / HINT

HINT:

Before performing this diagnostic procedure, make sure to perform the status check and make sure that the DCM/VIN registration information is correct.

Click here

PROCEDURE

  1. CHECK DTCs

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON and wait for 10 seconds.

(d) Turn on the Techstream.

(e) Clear the DTCs.

Body Electrical > Telematics > Clear DTCs

(f) Check the DTCs again.

Body Electrical > Telematics > Trouble Codes

Result:

Result

Proceed to

DTC B15CC is output

A

DTC B15CC is not output

B

B

CHECK FOR INTERMITTENT PROBLEMS

A
  1. REPLACE BACKUP BATTERY (BUB)

(a) Replace the backup battery (BUB) with a known good one and check whether the same problem occurs.

Click here

NOTICE:

The BUB (Back-Up Battery) must not be replaced while an ACN call is in progress.

Click here

NEXT
  1. CLEAR DTCs

(a) Clear the DTCs.

Click here

NEXT
  1. CHECK DTCS AGAIN

(a) Check whether DTCs are output again and whether the same problem occurs.

Click here

OK:

No DTC is output.

OK

END

NG
  1. REPLACE DCM (DATA COMMUNICATION MODULE)

(a) Replace the DCM (telematics transceiver).

Click here

NOTICE:

  • The ignition switch must be in the OFF position.
  • Do not swap the DCM (telematics transceiver) with a DCM from another vehicle.
NEXT

PERFORM DCM ACTIVATION