Symptom Table
SYMPTOM TROUBLESHOOTING TABLE
HINT:
- Use the table below to determine the cause of the symptoms. If several suspected areas are listed, the possible causes of the symptom are shown in order of probability in the "Suspected Area" column of the table. Check each symptom, verifying the suspected areas in the order listed. Replace parts if necessary.
- Check the fuses and relays associated with this system before checking the suspected areas listed below.
Symptom | Suspected Area | Link |
|---|---|---|
The message "Communication Module failure detected, please contact your dealer" is displayed. |
Refer to the HEALTH CHECK section. |
|
Diagnostic Code Table (The red indicator has failed and cannot indicate a malfunction) |
||
The message "Communication Module Activation Failed" is displayed |
Contact the telematics service provider to check for possible network problems |
- |
Wait a few moments, then move to another location and try again (try to find a location with better signal reception) |
- |
|
Refer to the HEALTH CHECK section. |
||
Diagnostic Code Table |
||
The message "Unable to Connect the Emergency Call Center" or "Unable to Connect to the Call Center" is read |
Wait a few moments, then move to another location and try again (try to find a location with better signal reception) |
- |
Perform the "Vehicle Inquiry" procedure on the Techstream and check the subscription status |
- |
|
Refer to the UNABLE TO CONNECT TO CALL CENTER section |
||
The message "Safety Connect is not active" is read |
Perform the "Vehicle Inquiry" procedure on the Techstream and check the subscription status |
- |
Explain to the customer that the system is in inactive mode and confirm whether they want to change the mode |
- |
Symptom | Suspected Area | Link |
|---|---|---|
Green indicator abnormal (remains off) |
Refer to DCM POWER SOURCE CIRCUIT |
|
Refer to GREEN INDICATOR REMAINS OFF |
||
Red indicator abnormal (remains on) |
Refer to RED INDICATOR REMAINS ON |
|
Red and green indicators abnormal (remain off) |
Refer to RED AND GREEN INDICATORS DO NOT COME ON WHEN IGNITION SWITCH IS ON |
|
Refer to DCM POWER SOURCE CIRCUIT |
||
DCM (Telematics Transceiver) |
.gif)