Mobile Communication

How to Use Troubleshooting

~3min read

PRECAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the Safety Connect system.
  • *: Use the Techstream.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

NEXT
  1. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CONFIRMATION

HINT:

  • When troubleshooting, make sure the symptoms of the problem have been correctly identified. Any preconceptions must be set aside in order to make an accurate judgment. To clearly understand the actual symptoms of the problem, it is essential to ask the customer about the nature of the problem and the conditions under which it occurred.
  • Gather as much information as possible for reference. Previous problems that do not appear related to the current problem may also be very useful in some cases.
  • The following 5 elements are essential for analyzing the problem:

    What

    Vehicle model, system name

    When

    Date, time, frequency of occurrence

    Where

    Road conditions

    What were the conditions?

    Driving conditions, weather conditions

    How did it happen?

    Problem Symptoms

NEXT
  1. PRELIMINARY CHECKS

(a) Measure the battery voltage.

Standard voltage:

11 à 14 V

If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.

(b) Check the fuses and relays.

(c) Check the connectors and terminals for any abnormality, such as loose connections, deformation, etc.

NEXT
  1. CHECK CUSTOMER SUBSCRIPTION ACTIVATION*

(a) Enter the vehicle identification number in Vehicle Inquiry on the Techstream and check the subscription type and expiration date.

NEXT
  1. PERFORM HEALTH CHECK PROCEDURE*

(a) Perform the "Health Check" procedure and check the current DTCs.

Click here

Result:

Result

Proceed to

No DTCs are output

A

DTCs are output

B

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

A
  1. SYMPTOM TROUBLESHOOTING TABLE

(a) Refer to the Symptom Troubleshooting Table.

Click here

Result:

Result

Proceed to

The malfunction is not listed in the Problem Symptoms Table

A

The malfunction is listed in the Problem Symptoms Table

B

HINT:

If the symptom does not recur and no DTCs are output, try to reproduce the symptoms.

Click here

B

GO TO STEP 8

A
  1. GENERAL ANALYSIS AND TROUBLESHOOTING*

(a) ECU terminals

Click here

(b) Data List/Active Test

Click here

NEXT
  1. REPAIR OR REPLACE

(a) Check whether the DCM (Telematics Transceiver) has been replaced.

Result:

Result

Proceed to

The DCM (Telematics Transceiver) has been replaced

A

The DCM (Telematics Transceiver) has not been replaced

B

B

GO TO STEP 10

A
  1. PERFORM DCM ACTIVATION

(a) Perform the "DCM ACTIVATION" operation.

Click here

NEXT
  1. CONFIRMATION TEST

NEXT

END