Mobile Communication

GPS Antenna Circuit Short (B15C0, B15C1)

~5min read

DESCRIPTION

These DTCs are stored when the DCM (telematics transceiver) detects an open or short circuit in the roof-side telephone and GPS antenna assembly circuit. The DCM (telematics transceiver) receives radio frequency signals of 1,574.42 - 1,576.42 MHz from satellites through the roof-side telephone and GPS antenna assembly. The cable is a 50 Ω coaxial cable.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

B15C0

GPS Antenna Circuit Short

The resistance (Ω) of the roof-side telephone and GPS antenna assembly is lower than the malfunction threshold for 10 seconds with the ignition switch ON.

(Short Circuit)

  • DCM (Telematics Transceiver)
  • Telephone and GPS Antenna Assembly (Roof Side)
  • Telephone and GPS Antenna Cable (Antenna Cable Sub-assembly No. 3)
  • Telephone and GPS Antenna Cable (Antenna Cable Sub-assembly No. 6)

B15C1

GPS Antenna Circuit Open

The resistance (Ω) of the roof-side telephone and GPS antenna assembly is higher than the malfunction threshold for 10 seconds with the ignition switch ON.

(Open Circuit)

  • DCM (Telematics Transceiver)
  • Telephone and GPS Antenna Assembly (Roof Side)
  • Telephone and GPS Antenna Cable (Antenna Cable Sub-assembly No. 3)
  • Telephone and GPS Antenna Cable (Antenna Cable Sub-assembly No. 6)

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

HINT:

  • Before performing this diagnostic procedure, make sure to perform the status check and make sure that the DCM/VIN registration information is correct.

    Click here

  • Refer to the "COMPONENT LOCATION" section for the installation location of the GPS and telephone antenna cable.

    Click here

PROCEDURE

  1. CHECK DTCs

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON and wait for 10 seconds.

(d) Turn on the Techstream.

(e) Clear the DTCs.

Body Electrical > Telematics > Clear DTCs

(f) Check the DTCs again.

Body Electrical > Telematics > Trouble Codes

Result:

Result

Proceed to

DTC B15C0 or B15C1 is output

A

DTC B15C0 or B15C1 is not output

B

B

CHECK FOR INTERMITTENT PROBLEMS

A
  1. INSPECT GPS AND TELEPHONE ANTENNA CABLE (ANTENNA CABLE SUB-ASSEMBLY NO. 6)

(a) Disconnect the E connector of the GPS and telephone antenna cable (antenna cable sub-assembly No. 6) from the GPS and telephone antenna cable (antenna cable sub-assembly No. 3).

*a

Component without harness connected (GPS and telephone antenna cable (antenna cable sub-assembly No. 6))

(b) Disconnect the C connector of the GPS and telephone antenna cable (antenna cable sub-assembly No. 6) from the DCM (telematics transceiver).

*a

Component without harness connected (GPS and telephone antenna cable (antenna cable sub-assembly No. 6))

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

E-2 - C-1

Always

Below 1 Ω

E-2 or C-1 - Body ground

Always

10 kΩ minimum

E-2a - C-1a

Always

Below 1 Ω

E-2a or C-1a - Body ground

Always

10 kΩ minimum

NG

REPLACE GPS AND TELEPHONE ANTENNA CABLE (ANTENNA CABLE SUB-ASSEMBLY NO. 6)

OK
  1. INSPECT GPS AND TELEPHONE ANTENNA CABLE (ANTENNA CABLE SUB-ASSEMBLY NO. 3)

(a) Disconnect the F connector of the GPS and telephone antenna cable (antenna cable sub-assembly No. 3) from the GPS and telephone antenna assembly (roof side).

*a

Component without harness connected (GPS and telephone antenna cable (antenna cable sub-assembly No. 3))

(b) Disconnect the E connector of the GPS and telephone antenna cable (antenna cable sub-assembly No. 3) from the GPS and telephone antenna cable (antenna cable sub-assembly No. 6).

*a

Component without harness connected (GPS and telephone antenna cable (antenna cable sub-assembly No. 3))

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F-5 - E-2

Always

Below 1 Ω

F-5 or E-2 - Body ground

Always

10 kΩ minimum

F-5a - E-2a

Always

Below 1 Ω

F-5a or E-2a - Body ground

Always

10 kΩ minimum

NG

REPLACE GPS AND TELEPHONE ANTENNA CABLE (ANTENNA CABLE SUB-ASSEMBLY NO. 3)

OK
  1. REPLACE GPS AND TELEPHONE ANTENNA ASSEMBLY (roof side)

(a) Replace the GPS and telephone antenna assembly (roof side) with a known good one and check whether the same problem occurs.

Click here

OK:

The system returns to normal.

OK

END

NG
  1. REPLACE DCM (DATA COMMUNICATION MODULE)

(a) Replace the DCM (telematics transceiver).

Click here

NOTICE:

  • The ignition switch must be in the OFF position.
  • Do not swap the DCM (telematics transceiver) with a DCM from another vehicle.
NEXT

PERFORM DCM ACTIVATION