Mobile Communication

Ignition Switch Signal Malfunction (B15C6)

~2min read

DESCRIPTION

If vehicle movement (for a minimum of 10 seconds 10 km/h) is detected based on location data transmitted by the audio unit, even when the telematics transceiver detects that the ignition switch is in the OFF position, this DTC will be stored.

DTC No.

Detection Item

DTC Detection Condition

Suspected Area

B15C6

Ignition Switch Signal Malfunction

IG Signal Error

  • Wire harness or connector
  • DCM (Telematics Transceiver)

WIRING DIAGRAM

PRECAUTION / NOTICE / HINT

NOTICE:

Check the fuses for the circuits related to this system before performing the following procedure.

PROCEDURE

  1. CHECK WHETHER DTCs ARE OUTPUT

(a) Clear the DTCs.

Click here

Body Electrical > Telematics > Clear DTCs

(b) Check whether other DTCs are output and check whether the same DTC is output again.

Click here

Body Electrical > Telematics > Trouble Codes

Result:

Result

Proceed to

B15C6 is not output.

A

B15C6 is output.

B

A

USE SIMULATION METHOD TO CHECK

B
  1. CHECK HARNESS AND CONNECTOR (DCM [TELEMATICS TRANSCEIVER] - BATTERY AND BODY GROUND)

(a) Disconnect the DCM (telematics transceiver) connector.

*a

Front view of wire harness side connector

(to DCM [Telematics Transceiver])

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

F134-4 (E) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) shown in the table below.

Standard voltage:

Tester Connection

Ignition switch position

Specified Condition

F134-7 (IG2) - Body ground

Ignition Switch in ON position

11 à 14 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
  1. REPLACE DCM (DATA COMMUNICATION MODULE)

(a) Replace the DCM (telematics transceiver).

Click here

NOTICE:

  • The ignition switch must be in the OFF position.
  • Do not replace the DCM (Telematics Transceiver) with one from another vehicle.
NEXT

PERFORM DCM ACTIVATION