Green Indicator Light Stays Off
DESCRIPTION
After the ignition switch is turned to ON, the DCM (telematics transceiver) enters self-diagnosis mode. The manual SOS red indicator light comes on for 2 seconds and then turns off, after which the manual SOS green indicator light comes on and stays on under normal operating conditions. If neither the red nor green indicator light stays on, subscription verification must be performed.
PROCEDURE
CONFIRM THAT THE GREEN INDICATOR LIGHT STAYS ON
(a) After turning the ignition switch to ON, the manual SOS red indicator light comes on for 2 seconds. Make sure the manual SOS green indicator light comes on.
OK:
The green indicator light comes on.
| NG | GO TO STEP 6 |
|
CONFIRM SUBSCRIPTION MODE
(a) Check the indicator light condition 5 seconds after the ignition switch is turned to ON.
Result:
Result | Proceed to |
|---|---|
The green indicator stays on |
A |
The green indicator stays off |
B |
Red and green indicator lights flash (at 1-second intervals for 20 seconds) |
C |
HINT:
If the red and green indicator lights flash, the system is in transport mode, so the system must be changed to active mode or inactive mode.
| A | CHECK FOR INTERMITTENT PROBLEMS |
| C | CHANGE SUBSCRIPTION MODE |
|
ENTER VIN INTO TECHSTREAM
(a) Turn the ignition switch OFF.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON and wait for 10 seconds.
(d) Turn on the Techstream.
(e) Select "Vehicle Inquiry" and enter the vehicle identification number (VIN).
|
CONFIRM SUBSCRIPTION MODE
(a) Check the indicator light condition 5 seconds after the ignition switch is turned to ON.
Result:
Result | Proceed to |
|---|---|
The green indicator stays on |
A |
The green indicator stays off |
B |
| A | END |
|
REPLACE DCM (DATA COMMUNICATION MODULE)
(a) Replace the DCM (telematics transceiver).
Click here![]()
NOTICE:
- The ignition switch must be in the OFF position.
- Do not swap the DCM (telematics transceiver) with a DCM from another vehicle.
| NEXT | PERFORM DCM ACTIVATION |
CHECK DTCs
(a) Turn the ignition switch OFF.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON and wait for 10 seconds.
(d) Turn on the Techstream.
(e) Perform the "Health Check" and check the current DTCs.
Click here![]()
Result:
Result | Proceed to |
|---|---|
No DTCs are output |
A |
DTCs are output |
B |
| B | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
REPLACE DCM (DATA COMMUNICATION MODULE)
(a) Replace the DCM (telematics transceiver).
Click here![]()
NOTICE:
- The ignition switch must be in the OFF position.
- Do not swap the DCM (telematics transceiver) with a DCM from another vehicle.
| NEXT | PERFORM DCM ACTIVATION |