Backup Battery Degradation (B15EC)
DESCRIPTION
This DTC is output when the DCM (Telematics Transceiver) detects either of the following two conditions.
- The charge level of the backup battery (BUB) falls below the threshold.
- The backup battery (BUB) has been used for Automatic Collision Notification (ACN).
When this DTC is output, the backup battery (BUB) must be replaced.
DTC B15EC for backup battery degradation is not indicated in standby mode.
DTC No. | Detection Item | DTC Detection Condition | Suspected Area |
|---|---|---|---|
B15EC |
Back-Up Battery (BUB) Deterioration |
The backup battery (BUB) is depleted. |
Backup battery (BUB) |
PRECAUTION / NOTICE / HINT
NOTICE:
- If this DTC is output, be sure to replace the backup battery (BUB) with a new one.
- After replacing the backup battery (BUB), it is necessary to clear this DTC.
- The BUB (Back-Up Battery) must not be replaced while an ACN call is in progress.
Click here
.gif)
HINT:
Before performing this diagnostic procedure, make sure to perform the status check and make sure that the DCM/VIN registration information is correct.
Click here![]()
PROCEDURE
CHECK DTCs
(a) Turn the ignition switch OFF.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON and wait for 10 seconds.
(d) Turn on the Techstream.
(e) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs(f) Check the DTCs again.
Body Electrical > Telematics > Trouble CodesResult:
Result | Proceed to |
|---|---|
DTC B15EC is output |
A |
DTC B15EC is not output |
B |
| A | REPLACE BACKUP BATTERY (BUB) |
| B | CHECK FOR INTERMITTENT PROBLEMS |