AV Signal Stop (Low Battery Voltage) (B158F)
DESCRIPTION
This DTC is stored when an audio or video signal is interrupted due to a temporary drop in battery voltage input to the radio and display assembly.
DTC No. | Detection Item | DTC Detection Condition | Suspected Area |
|---|---|---|---|
B158F |
AV Signal Stop (Low Battery Voltage) |
A video or audio signal is interrupted when battery voltage drops |
|
WIRING DIAGRAM
PRECAUTION / NOTICE / HINT
NOTICE:
- Depending on the parts replaced during vehicle inspection or maintenance, initialization, registration or calibration may be required. Refer to the precautions for the navigation system.
Click here
.gif)
- When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly that was installed in another vehicle is reused, the following may occur:
- A communication malfunction DTC is stored.
- The radio and display receiver assembly may not operate normally.
- Check the fuses for the circuits related to this system before performing the following procedure.
PROCEDURE
CHECK VEHICLE SIGNAL (OPERATION CHECK)
(a) Select the "Vehicle Signal Check Mode" screen. Refer to Vehicle Signal Check in Operation Check. Click here |
![]() |
(b) Measure the battery voltage.
Standard voltage:
11 à 14 V
HINT:
This screen is updated every second.
| NG | GO TO STEP 3 |
|
CHECK DTCs
(a) Clear the DTCs.
Body Electrical > Navigation System > Clear DTCs(b) Check DTCs again and confirm that no DTCs are output.
Body Electrical > Navigation System > Trouble CodesOK:
No DTC is output.
| OK | END |
| NG | REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY ASSEMBLY POWER SOURCE)
(a) Disconnect the radio receiver and display assembly connector. |
|
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:
Tester Connection | Condition | Specified Condition |
|---|---|---|
F131-4 (+B1) - Body ground |
Always |
11 à 14 V |
| OK | REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
.png)
